Valore VS1205 Plus Guía De Instalación Y Usuario página 11

NOTE: If the water outlet is below 33.38" on the template, the PVC cover is not required.
1. Peel off the paper backing to the adhesive ring
for the Base Plate cover (Part 5).
2. Place the adhesive side to the wall and apply
pressure to secure the Base Plate Cover
(Part 5). (Note: Remove all residues to insure
the cover will bond properly)
3. Add a Filter Gasket (Part 11) into Elbow Joint
(Part 3) first.Then attach the Elbow Joint (Part 3)
to the Brass Extender Joint (Part 4), turn clock
wise to tighten.
4. Place the Showerhead Cover (Part 2) to
conceal plumbing fixture.
• After all connections have been completed
inside the shower panel, it is ready to be
hung on the shower wall for installation.
• Raise the shower panel and bringing it to the
surface of the shower wall and gently lower
it until the bracket support struts on the back
of the shower panel meet the support brackets
( Part 14) installed in Step 10. Please ensure the
brackets (Part 14) are centered on the groove
on the support struts.
• Once a snug and secure fit is achieved and all
parts of the PVC Supply Line are secured to the
back of the shower panel, silicone sealant can
be applied to seal the gap between the shower
panel casing and the shower wall to hold it in
place and prevent water from entering behind
the panel.
INSTALLATION INSTRUCTIONS
- 11 -
11
13
14
14