Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
a thrown object as the blade begins to turn.
■
Exercise extreme caution when using the
blade with this product. Blade thrust is the
reaction that may occur when the spinning
blade contacts anything it cannot cut. This
contact may cause the blade to stop for an
instant, and suddenly "thrust" the unit away
from the object that was hit. This reaction
can be violent enough to cause the
operator to lose control of the unit. Blade
thrust may occur without warning if the
blade snags, stalls, or binds. This is more
likely to occur in areas where it is difficult to
see the material being cut.
■
For cutting ease and safety, approach the
weeds being cut from the right to the left.
In the event that an unexpected object or
woody stock is encountered, this practice
could minimize the blade thrust reaction.
Both hands must be used at all times to
control this product.
TRANSPORTATION AND STORAGE
■
Stop the product and allow it to cool before
storing or transporting.
■
Clean all foreign materials from the product.
■
If a cutting blade is fitted, cover it with the
blade protector.
■
For storage, always disconnect from power
supply and wind the cable. Store it in a
cool, dry and well-ventilated place that
is inaccessible to children. Keep away
from corrosive agents, such as garden
chemicals and de-icing salts. Do not store
outdoors.
■
For transportation, secure the product
against movement or falling to prevent
injury to persons or damage to the product.
MAINTENANCE
WARNING
Use
only
original
replacement
parts,
attachments. Failure to do so can cause
possible injury, poor performance, and may
void your warranty.
manufacturer's
accessories,
and
WARNING
Servicing
requires
knowledge and should be performed
only be a qualifi ed service technician. For
service, we suggest you bring the product
to your nearest authorised service centre for
repair. When servicing, use only identical
replacement parts.
■
Switch off and remove battery back before
conducting any maintenance or cleaning
work.
■
You may make adjustments and repairs
described here. For other repairs, contact
the authorised service agent.
■
For the replacement line, use only nylon
filament line of the diameter described in
the specification table of this manual.
■
After extending the new cutter line, always
return the product to its normal operating
position before starting.
■
After each use, clean the product with a
soft dry cloth. Any part that is damaged
should be properly repaired or replaced by
an authorised service centre.
■
Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure the
product is in a safe working condition.
RESIDUAL RISKS
Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise in use and the operator
should pay special attention to avoid the
following:
–
Injury caused by vibration. Hold the
product by designated handles and
restrict working time and exposure.
–
Injury caused by exposure to noise.
Wear hearing protection and limit
exposure.
–
Injury caused by flying debris. Wear eye
protection at all times.
Contact with cutting means. Ensure that the
blade protectors are fi tted when the machine
is not in use. Keep hands and feet away from
the blades at all times.
Kickback
can
occur
brushcutter. Ensure proper control by using
both hands on the designated handles. Read
and follow the directions elsewhere in this
extreme
care
and
when
using
the
English |
5
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
Publicidad
Tabla de contenido
