Troubleshooting - Snapper XD SXDST82 Manual Del Propietário

TROUBLESHOOTINg

Problem Cause
1. The battery pack is not
attached to the trimmer.
2. No electrical contact
between the trimmer and
battery.
String trimmer
3. The battery pack is depleted. 3. Charge the battery pack.
fails to start
when trigger
lock button is
4. The lock-off lever and
depressed.
trigger are not depressed
simultaneously.
5. Did not press the power
button, press the trigger
directly.
1. The guard is not mounted
on the trimmer, resulting in an
overly long cutting and motor
overload.
2. Heavy cutting line is used.
3. The motor shaft or trimmer
head is bound with grass.
4. The motor is overloaded.
String trimmer
stops while
cutting.
5. The battery pack or string
trimmer is too hot.
6. The battery pack is
disconnected from the tool.
7. The battery pack is depleted. 7. Charge the battery pack.
solution
1. Attach the battery pack to the trimmer.
2. Remove battery check contact and reinstall
the battery pack.
4. Press down the lock-off lever and hold it,
then depress the trigger to turn on the string
trimmer.
5. Start the power button, the power indicator
will trigger later.
1. Remove the battery pack and mount the
guard on the trimmer.
2. Use only with nylon cutting line 0.08"
diameter or less.
3. Stop the trimmer, remove the battery, and
remove the grass from the motor shaft and
trimmer head.
4. Remove the trimmer head from the grass.
the motor will recover to work as soon as
the load is removed. when cutting, move the
trimmer head in and out of the grass to be cut
and remove no more than 8 inches of length
in a single cut.
5. Allow the battery pack to cool until the
temperature drops below 158°f (70°C).
Allow the trimmer to cool until the temperature
drops below 140°C.
6. Re-install the battery pack.
28