Stagnoli ZEFIRO-180 Manual Del Usuario página 10

Istruzioni instructions
Attention!
• This manual is for qualified installers only and not for the end user. It is the
installer's job to explain to the user how the automatism works, about possible
hazards related to it and the need for periodical maintenance.
• Installation must be carried out by qualified personnel only, observing current
standards concerning automatic closing systems. More specifically, installation
conformity calls for observance of directive 89/392 and standards EN 12453 and
EN 12445.
• ZEFIRO-180 has been made specifically to control the automation of swing
gates and it is therefore forbidden to use it for any other purpose or improperly.
• Use original components only. Stagnoli is not liable for damages if any other
components are used.
• Make absolutely certain the power is disconnected before carrying out any
work on the device.
• Be particularly careful when evaluating the safety devices to install and their
location. Always install an emergency stop device that will cut power off in the
case of necessity.
• The power lead must only be connected to supply lines fitted with adequate
electrical protection; a circuit breaker must also be installed to guarantee
disconnection of all the phases from the mains with a distance of at least 3.5
mm between the contacts.
• Only qualified personnel must be allowed to service the unit, including changing
the courtesy light bulb whenever needed.
• Make sure that the gate structure is solid, well balanced and suitable to be
motorised. Also ensure there are no points of friction when the gate is moving.
Instructions
Instrucciones Anleitungen
10