project mc2 H2O Guía De Inicio

EN
H2O Nail Science Kit
SKU: 545156
CONTENTS
A. 1 Base with LED light
E. 4 Pipettes
B. 1 Beaker F. 3 Nail Disks
C. 3 Nail Polish Holders
G. 1 Nail Adhesive Sheet
D. 1 Stir Stick
A.
B.
C. x 3 D.
Illustrations are for reference only.
Styles may vary from actual contents.
YOUR HOUSEHOLD ITEMS
(Not Included)
Ask an adult to help you gather all the household items needed and supervise during the experiment.
H. 2 or more Nail Polishes
I. Tape
H. I.
J. Water
K. Nail Polish Remover
L. Cotton Swabs
BATTERY INSTALLATION
Before playing, an adult must install fresh alkaline batteries in the nail base. Here's how:
1. Using a Phillips screwdriver (not included) remove the screw and battery compartment cover from under
the nail base.
2. Install three (3) fresh 1.5V AA (LR6) alkaline batteries (not included) making sure the (+) and (-) ends face
the proper direction as indicated inside the battery compartment.
3. Replace the compartment cover and tighten the screw.
8+ YEARS
CAUTION:
Contains functional sharp point.
Keep away from small children.
1
ADULT SUPERVISION REQUIRED
F. x 3
Insert the three nail polish holders into the
openings on the base.
G.
E. x 4
4
J. K.
Shake all nail polishes. With the baskets
facing inward, place a nail polish in each
L.
holder and twist open the nail polish caps.
3 x AA Batteries
1.5V AA/LR6
1.5V AA/LR6
1.5V AA/LR6
GETTING STARTED
NOTE: Before beginning, cover the play area to avoid possible damage.
2
Place the beaker in the center of the base.
5
Fill the beaker 3/4 full of water.
7
Pull off the appropriate size nail and stick it
on top of the nail adhesive.
3
ON
Move the switch on the back of the base
to the ON position. The base will light up.
6
Select the appropriate size adhesive for each
nail. Peel off the adhesives and apply to your
nails. Then, peel off the top layer.
8
Mask off the area around your nails with tape.
IMPORTANT : Only the nails should be exposed.
Thoroughly cover fingertips.
OFF