EVERSPRING SP818 Guía De Usuario página 3

7. At this point, insert the battery with correct polarity into the unit.
8. The screen below will appear in 10 seconds if the process is successful.
9. Time-out will occur if the binding process was unsuccessful. Please refer to the "Manual binding"
section.
Note: Leave the detector with the rear cover open to prepare for testing.
Manual Binding
1. Repeat steps 3 to 6 of the Binding with Homesys section.
2. With the battery inserted, press and hold the Link button on the PCB for 3 or more seconds, and
the detector LED will start to flash, implying that it has entered ID code learning mode.
3.
4.
Testing
Warm-Up
It will take approximately 1 minute to warm up the Detector after a battery is inserted. During this period
the LED will flash red slowly. When the LED turns red for 5 seconds, it implies warm-up procedure is
complete and the detector is ready for detection.
Testing
1.
Link
button
2.
3.
4.
2
The LED indicator will stop flashing and turn off within 5 seconds, indicating the learning procedure
is completed. The screen below will appear indicating the process is successful.
If after 30 seconds the LED flashes rapidly (with an interval of 0.1 second) for 3 times, it means the
PIR failed the binding process.
Go to System, and set it to ARM.
Wait for 30 secs then wave your hand in front of the detector.
If the test is successful the system will trigger an alarm (alarms are listed in "Events").
Note: It is necessary that the Homesys gateway is powered and connected to internet.
If the test is unsuccessful, please check the troubleshooting section.