To Change The Ribbon - Sagem Photo Easy 260 Manual Del Usuario

All manuals and user guides at all-guides.com
Liasse AZUR_GB.book Page 8 Lundi, 23. mai 2005 11:31 11
T
O CHANGE THE RIBBON
Remark: use manufacturer consumables only. These are specially designed to provide optimum
print quality.
Switch on the printer. Wait 10 seconds for the printhead to lift, then:
1. Take the smart card supplied with the ribbon and photo paper and insert it
in the reader on the printer's left-hand side. The smart card is recognised
and read by the printer, and once the procedure is complete the
wording: "Transfer OK (40) - Remove card" or "Transfer OK (120) -
Remove card" appears on screen.
2. Remove the SIM card.
3. Take the new ribbon out of its packaging and make sure that the film is
stretched after removing the card (A).
4. Open the external flap located on the right-hand side of the printer.
5. Lift the locking lever and remove the used ink ribbon.
6. Install the ribbon in the position shown in the illustration below.
7. Lift the locking lever and push in the film cartridge until it touches the
back of the compartment the locking lever must be locked after insertion.
8. Close the external flap.
Remark: if the ribbon is replaced during a print job, you can resume printing where you left off
by pressing the button.
- 8 -