Tabla de contenido
Publicidad
Warnings
Use only the provided power supply. Use of unauthorized power supply may damage the WRP.
The WRP does not have mains on/off switch. Make sure that the access to the mains outlet is never obstructed.
Do not use extension cords to plug in the power supply.
Do not connect the repeater to electrical outlets on the same circuit as large appliances.
Do not connect the repeater to electrical outlets controlled by wall switches or automatic timers.
Do not mount the repeater inside a metal enclosure or on metalized wallpaper.
Mounting guidelines
Mount the repeater at least 3 meters away from any electrical device that generates "noise".
The repeater must not be exposed to direct heat sources or direct sunlight.
Contact with spraying or dripping water and aggressive liquids must be avoided.
The AC outlet for the power supply should be located near the repeater and be easily accessible.
How to mount and connect the WRP
Mount the WRP box on a flat surface. Follow the next steps.
1.
Insert a slotted screwdriver to the niches at the bottom and remove the cover.
2.
Set the WRP Dip switch; see instructions below.
3.
Connect the power supply to its socket. Alternatively you can connect the power supply wires to the
(no. 5 in the figure above). Observe polarity!
4.
Connect the battery connector (no. 2 in the figure above).
5.
Set the repeater in the control panel (see how in the Installation guide) and check the LEDs; see below.
6.
Close the box.
The Dip switches
No. Label
Options (ON)
1-3
Add 1-3
Set the repeater's address (1-8
4
Option
Not in use in this model
5
Bypass
Allows powering-up the WRP on battery power only
6
Cur. Cont.
Battery charging control:
Switch ON: 400mA
Switch OFF: 200mA
7
BOOT
Firmware update (for PIMA use only): must be in Off position.
8
LED Charge
The Power LED will blink to indicate when the battery is being charged
The LEDs
label
Color and state Description
Rx
Green, blinking
Tx
Purple, blinking
Power Green, solid
Green, blinking
Red, blinking
Lithium-ion battery safety guidelines
Do not use the battery for any purpose other than backing up the WRP.
Do not throw the battery into fire, nor heat the battery.
Do not disassemble nor modify the battery.
Do not keep the battery in a temperature higher than 60° Celsius.
Do not expose the battery to water or moisture.
Do not solder leads directly to the battery body.
Do not short the battery +/- terminals with any kind of metal.
Do not reverse charge the battery.
Do not puncture the battery with any object.
Ordering information
WRP143 P/N: 8831020
1
Depending on the FORCE's system version
1
); the optional addresses are:
The repeater's address must be the same as the WRP
number in the control panel.
Reception
Transmission
Powered by AC power
Powered by Battery power
Battery charging
WRP187 P/N: 8831030
-2-
Ext. Power
terminal block
Publicidad
Tabla de contenido
