Publicidad
RECESS MOUNTING
These instructions are for recess mounting your cabinet. Before beginning installation remove and set the door aside in a safe place.
NOTES: The cardboard sleeve attached to the door protects the edges and corners of the door during installation.
Ensure that the cabinet is mounted so that the door has at least 1" (25mm) clearance from the top of the faucet and at least 1" (25mm)
clearance from the ceiling.
1. Remove door from cabinet by taking the hinges off of the mounting plates.
2. Make rough opening and frame on all sides. Find the specific model dimensions to make rough opening (page 5).
3. Electrical Option Cabinets: Provide a separate electrical connection for electrical options and lighting. Pull electric wire through the
hole. Be sure to provide enough wire to make proper and safe connections to Portray Electric Upgrade.
WARNING: An Electrical option cabinet must be wired to a Class A 20 Amp GFCI (Ground Fault Circuit Interrupter) protected circuit
when used in bathrooms and all other locations required by the National Electric Code.
1
2
© 2020 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
3
1" (25.4 mm)
Minimum from
finished ceiling
1-1/4"
6
Rough Opening
Field Wiring
(For Electric Option)
Rough Opening
Centered in opening
Minimum door
Part no. CB-209-1350 10/27/20
1" (25.4 mm)
to faucet
PL Portray Cabinet
Publicidad
Capítulos
