Astralpool LumiPlus Design Manual De Instalación Y Mantenimiento página 4

Prefabricated pool
Fit the ring inside the niche using the appropriate screws for the niche, with "TOP" positioned in the upper section
(Fig. 5).
3. Install the cable gland fitting "A" through the inside of the niche with the butt joint "B". The screw can be reinforced
with Teflon (Fig. 6 -7).
4. To connect the lamp to the power supply, the cable should be introduced into the cable gland of the niche. Tighten the
cable gland screw, ensuring that it does not move when you pull the cable by hand (Fig. 7).
5. Install the spotlight inside the niche (Fig. 8), ensuring that the fastening screw is positioned in the upper section.
6. Position the pressurised cover (Fig.9).
For installations in which you wish to replace a spotlight with a LumiPlus Design projector, avoid underwater fittings
(see Fig.10)
1. Unscrew the two screws holding the cable gland and pull hard.
2. Disassemble the LumiPlus Design cable gland and remove the cable.
3. Choose the cable gland joint, included in the LumiPlus Design, that is best adapted to the diameter of the niche cable
and clamp fast-on sockets (6.35 x 0.8 not included) to the existing cable.
4. Reassemble the cable gland, reconnect the fast-ons to the lamp and screw in the two screws.
Changing the cover plate (see Fig.11)
Remove the cover, unscrew the lower screw (black) and remove the lamp from the niche. With the help of a screwdriver,
remove the fastening clip and take out the bolt, replace the bolt and reassemble.
5. SAFETY AND MAINTENANCE WARNINGS:
• Before any handling ensure that there is NO voltage supplied to the projector.
• People in charge of assembly should be suitably qualified for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING
POOLS.
• Do not handle with wet feet.
• Do not clean using abrasive products that could damage the projector.
• The LEDs in this projector are classified as risk group 2.
• Under no circumstances should the luminaire be stared into for one minute or more at distances equal to or less than
20 cm. Doing so could damage eyesight.
6. ASSEMBLY AND FUNCTIONING WARNINGS:
• Maximum water temperature 40ºC.
• It is not recommended the use of sealing putty in this product and, anyway, you should use only products specifically
conceived to work with ABS, all those products of universal use remain excluded.
• The projector is designed TO OPERATE ONLY WITH A SAFETY TRANSFORMER.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric compo-
nents which have been inserted or handled at locations other than its own premises.
• It is responsibility of the installer to ensure that no water gets inside the projector by means of the cables.
• This projector is seawater resistant.
• This projector is resistant to pool treatments described below, always that the concentration values do not exceed the
following levels:
Chlorine
Bromine
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
TYPE OF TREATMENT CONCENTRATION IN WATER
2 mg/l
5 mg/l
4