Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS
MIRROR INSTALLATION
1. Remove the back-plate from the wall base by unscrewing the
top and bottom screws.
2. Carefully select the wall mirror location. It is suggested the
mirror be attached to a stud. Hold the back-plate up to the wall and
ensure it is vertical with a level. Mark the locations of the top and
bottom holes on the wall.
3. If no stud is available, use the supplied plastic anchors. Drill a
5/16" hole into drywall/wallboard, tile, plaster, brick, or concrete at
the location you marked. Insert the wall anchor into the hole. Tap
until anchor flange is flush with the wall.
4. Align the back-plate holes with either the locations marked in
Step 2 or the plastic anchors in Step 3. Using the screws from the
hardware bag, mount the back plate onto the wall by tightening both
screws.
5. Continue to tighten screw until there is a strong resistance. DO
NOT OVER TIGHTEN.
6. Place the wall base on top of the back-plate. Tighten both
screws that were removed in Step 1 until the wall base is firm and
does not move.
© 2021 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Magnification Mirror
Mounting Hardware Bag
(2) Wall Anchor
2
2
[216-1226]
(2) Screws
Top Hole
Bottom Hole
Part no. 209-1379 1/20/21
Unlit, Wall-Mounted, 1x/7x Magnification Mirror
Publicidad
