Troubleshooting; Care And Maintenance - Pro-Lift Surface Works I-4510 Instrucciones De Funcionamiento Y Manual De Partes

TROUBLESHOOTING

Problem
Buffer will not start
Buffer performs poorly
Buffer vibrates excessively

CARE AND MAINTENANCE

1. Remove extension power cord prior to storing.
2. Store polisher with pad face up to prolong pad life and shape.
3. Remove and wash bonnet when polisher is not in use.
4. Use only mild soap and a damp sponge to clean the exterior of the polisher. Do not immerse any part of the
polisher in liquid. If the polisher requires repair, consult a qualified repair person.
5. Wash buffer pad bonnets after each use. Hand wash with warm water and mild detergent. Dry thoroughly. Repeat
as needed to remove all traces of wax, dirt, and residue. Replace buffer pad covers when they become stiff or
permanently stained. For replacement bonnets, contact Pro-Lift Customer Support, 10939 N. Pomona Ave.,
Kansas City, MO 64153. Phone (816) 891-6390, Fax (816) 891-6599
90 DAYS LIMITED WARRANTY
For a period of 90 DAYS from date of purchase, SFA Companies, Inc. will repair or replace, at its option, without
charge, any of its products which fails due to a defect in material or workmanship under normal usage. This limited
warranty is a customer's exclusive remedy.
Performance of any obligation under this warranty may be obtained by returning the warranted product, freight
prepaid, to SFA Companies, Inc. Warranty Service Department, 10939 N. Pomona Ave., Kansas City, MO 64153.
Except where such limitations and exclusions are specifically prohibited by applicable law, (1) the CONSUMER'S
SOLE AND EXCLUSIVE REMEDY SHALL BE THE REPAIR OR REPLACEMENT OF DEFECTIVE PRODUCTS
AS DESCRIBED ABOVE, and (2) SFA Companies, Inc. SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL
OR INCIDENTAL DAMAGE OR LOSS WHATSOEVER. (3) ANY IMPLIED WARRANTIES, INCLUDING WITHOUT
LIMITATION, ANY WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL
BE LIMITED TO 90 DAYS, OTHERWISE THE REPAIR, REPLACEMENT OR REFUND AS PROVIDED UNDER
THIS EXPRESS LIMITED WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER, AND IS PROVIDED
IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. (4) ANY MODIFICATION, ALTERATION, ABUSE,
UNAUTHORIZED SERVICE OR ORNAMENTAL DESIGN VOIDS THIS WARRANTY AND IS NOT COVERED BY
THIS WARRANTY.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply
to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
Possible Cause
Power cord not plugged in
Fuse blown or breaker tripped
Power cord damaged
Faulty power switch
Overheating
Excess polish on bonnet
Worn or dirty bonnet
Bonnet not secured
Loose buffer components
SFA Companies
10939 N. Pomona Ave. Kansas City, MO 64153
Phone: (816) 891-6390, Fax: (816) 891-6599
Plug power cord in outlet
Replace fuse or reset breaker
Contact authorized service center
Contact authorized service center
Turn buffer off and allow to cool
Replace or clean bonnet
Replace or clean bonnet
Ensure bonnet properly covers foam pad
Tighten fasteners or contact authorized
service center
4
Solution