Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 64
3. Saving a sound you created
In this section you'll learn how to save a sound you've created. We'll
save your new sound in bank A, channel 1.
* For details on initializing the memory, refer to 5. Factory reset
1) Make sure that the
Display indicates M. Then, hold down the switch
5
marked "1" for three seconds or longer. When the settings have been
saved, the
Display will indicate A1, and will blink.
5
Note: Each channel consists of two banks, A and B. If you
want to save settings in bank A, channel 1 as described in this
tutorial after creating your sound in manual mode, you must
first click "1", make sure that you're currently in bank A, and
then click the MANUAL switch once again to return to manual
mode before you proceed with the following steps.
Hold down for three seconds or longer.
A sound you create in manual mode as described here can be saved in
any channel. A sound you create in each bank can be saved in a chan-
nel within that bank.
Here's an example.
2) Up to this point, we've used bank A, channel 1 to create a sound, but
now we're going to slightly adjust the position of each control and save
the result in bank A, channel 2. Perform the following steps.
Hold down for three seconds
Edit the sound of
or longer
bank A, channel 1
By saving your edited sound in another channel, you'll be able to com-
pare the two sounds. Next we're going to try using rhythm patterns.
4. Using rhythm patterns
This section explains how to use rhythm patterns.
1) We'll start by playing a rhythm. Click the ON/OFF switch. The TAP
switch will blink, and you'll hear drum sounds.
Note: Use the RHYTHM knob to adjust the volume appropriately.
2) Next we'll change the pattern. Press + or - until the
cates 16.
3) Let's make the tempo a bit faster. Click the TAP switch several times
at a consistent rhythm until the
Play a rhythm pattern
You can use rhythm patterns by following the procedure described above.

5. Factory reset

This section explains how to initialize the amp to the factory-set condi-
tion.
1) While holding down the MANUAL switch as shown in the illustration
below, turn on the
2) If you press the MANUAL switch in this state, all data will return to the
factory-set condition.
3) If you decide to cancel without resetting, operate any control other
than the MANUAL switch. You will exit factory reset mode.
The sound is saved
in bank A, channel 2
While holding down the
MANUAL switch, turn on
the POWER switch.
Display indicates 120.
5
Change the rhythm pattern
Change the rhythm speed
POWER switch. The
Display will indicate AL.
11
5
The display will
indicate AL.
Display indi-
5
Click the MANUAL
switch.
13

Publicidad

Tabla de contenido
loading

Productos relacionados para Ibanez MIMX150H

Este manual también es adecuado para:

Mimx65

Tabla de contenido