Nostalgia Products CCP610 Instrucciones Y Recetas página 9

Assembly of Base Support
1. Push Handle (E) attaches onto the Concession Stand (C)
using four #1 Screws and four #5 Flat Washers.
2. Insert Cross Bar (J) into the square inserts on the inside of Base Support (I) and secure
from below with two #1 Screws and two #5 Flat Washers. Insert the Leg Assembly
(K) into the square inserts between the ends of the Base Support (I) and fasten from
inside with two #2 Bolts, four #4 Flat Washers, two #3 Spring Locking Washers and two
#6 Nut Caps. Also secure from above with two #1 Screws and two #5 Flat Washers.
3. Assemble Base Support (I) into the bottom of the Concession Stand
(C) and secure with four #1 Screws and four #5 Flat Washers.
7