Installation Instructions - Whirlpool W11050563 Instrucciones De Instalación

INSTALLATION INSTRUCTIONS

1.
Move washer
48"
(1.2 m)
Move washer to within 48" (1.2 m) of its final location. It must
be in a fully upright position.
IMPORTANT: Keep the feet on the washer even in a stacked
installation. Remove all shipping materials, including the
shipping bolts, for proper operation and to avoid excessive
noise and vibration from the washer.
2.
Ensure washer is level in its final
location
Place level here.
Place a level on the top edges of the
washer, checking each side and front. If it is not level, tip
the washer and adjust the feet up or down as shown in
the Installation Instructions, repeating as necessary.
Not Level
4
LEVEL
Not Level
3.
On covering, lay dryer on side or back
Place a covering, such as cardboard or a blanket, on the floor
to avoid damage. Gently lay the dryer down with its side or
back on covering.
4.
Remove rear feet of dryer
and install caps
Using a wrench or slip-joint pliers, make sure the front feet
of the dryer are screwed in fully; then remove the rear feet.
Install the vinyl caps on the rectangular supports behind
the rear feet.