Door Station Settings; Controlling Somfy Rts Wireless Equipment; Add A Somfy Rts Device (Radio Technology Somfy) - SOMFY V100+ Manual De Instalacion Y Uso

EN

6.2 Door station settings

6.2.1 Adjust the speaker volume
To adjust the door
screwdriver to turn the button on the back of the door station:
• clockwise to increase the volume.
• anticlockwise to decrease the volume.
6.2.2 Set the audible signal of the call button
Two sound levels are available: low / high.
Press the call button for 5 seconds until you hear the audible signal
indicating whether the current sound level is high or low.
Press again for 5 seconds to change the status.

7. CONTROLLING SOMFY RTS WIRELESS EQUIPMENT

The monitor is equipped with a Somfy Radio Technology (RTS) transmitter. It is only compatible with devices equipped with Somfy Radio Technology (RTS).
It is used to control the following Somfy equipment, individually or simultaneously:
• garage door motorisation,
• lighting receiver,
• roller blind motorisation,
• gate motorisation.
This functionality is possible thanks to a system of radio channels, identified by indicator lights.
Each channel corresponds to an individual remote control and can be used to control one or more devices. There is no limit to the number of devices that can be
controlled by a single channel. The "select" channel selection button is used to navigate between channels.
Selecting the chosen channel to wirelessly control a piece of equipment
Press the "select" channel selection button: the indicator light for the selected channel will flash.
Press the "select" channel selection button as many times as necessary until the indicator lights
show the required channel.
Note: All the indicator lights comes on to indicate the 5th channel.
Important: Check that the equipment to be controlled wirelessly is not too far away from the monitor.

7.1 Add a Somfy RTS device (Radio Technology Somfy)

To add an RTS device (radio technology Somfy), you must carry out 2 steps:
- identify the original RTS control for the equipment (remote control, transmitter, etc.)
- pair the monitor with the RTS device on the channel of your choice
Example: Adding a Somfy RTS roller shutter
Note: The monitor must be connected to the power supply to carry out this procedure.
[1]. Identify the original control of the roller shutter, i.e. the remote control or the control point which only controls this roller shutter.
Note: - If the original control is lost or broken, and it is the only one to control the roller shutter, contact one of our Somfy advisors.
- If another control operates the roller shutter, use that to follow the steps below.
[2]. Partially open the roller shutter using the original control.
[3]. Press the PROG button on the original control until the roller shutter makes an up and down movement (or a series of 3 beeps). The programming
function is activated for 2 minutes.
[4]. Select a free channel by pressing the "select" channel selection button on the monitor.
[5]. Use a fine-tipped object to make a short press on the PROG button on the right-hand section of the monitor. The roller shutter will make an up and
down movement (or a series of 8 beeps).
11
station speaker volume, use
Video phone V100+
Button to
adjust the
speaker
volume
STOP
SELECT
Copyright © 2019 SOMFY ACTIVITES SA. All rights reserved.
a