Blaupunkt BP2203 Pautas De Seguridad página 13

Drill / Impact Switch (Fig 2)
The drill / impact switch (1) changes the drilling mode between
conventional drilling and impact for drilling concrete. To
operate the drill in drill mode, push the drill / impact switch to
the right (Fig 2A). To operate the drill in impact mode, push the
drill / impact switch to the left (Fig. 2B).
Installing Drill Bits (Fig. 3)
WARNING: Never hold the chuck body with one hand and use the drill power to rotate the drill body to loosen or tighten bits.
Serious injury may result.
• Remove drill plug from the power source.
• Rotate chuck collar (1) in a counter clockwise direction until the chuck jaws (2) open wide enough to accept the bit (3).
• Insert the bit into the chuck the full length of the jaws or until the spiral portion of the bit is near the chuck jaws. Raise the
front of your drill slightly to prevent the bit from falling out of the chuck jaws.
• Tighten the chuck jaws onto the bit by turning the chuck body in a clockwise direction.
• NOTE: Make sure the bit is properly aligned in the jaws and NOT at an angle. An improperly aligned bit could be thrown from
the chuck when the drill is started.
• Finish tightening the chuck jaws by inserting the chuck key (4) into one of three holes (5) in the chuck body. Rotate chuck key
clockwise until drill bit is held firmly in place by the chuck jaws.
Fig. 3
Removing Drill Bits (Fig. 3)
• Remove the drill plug from the power source.
• Insert the chuck key (4) into one of the three holes (5) in the chuck body. Rotate the chuck key counter clockwise until the
chuck jaws release the drill bit
Trigger Switch Lock (Fig. 4)
The trigger switch lock-on feature allows the trigger switch to be locked in the ON position at full speed when continuous operation
for extended periods of time is required.
• To lock the trigger switch in the ON position, pull back on the trigger switch (2) to start the drill. Continue to squeeze the
trigger until the drill reaches its maximum speed. Push the trigger switch lock button (3) into the drill handle. Release the
trigger switch while holding the trigger switch lock button into the drill handle. The drill will continue to run at full speed.
• To release the trigger switch lock button, pull the trigger switch back and then release the trigger.
Fig. 2A
Fig. 4
Fig. 2B