CHIEF iCMPDA1 Instrucciones De Instalación página 16

iCMPDA1
3D
100 x 100mm Recessed Mounting Hole Pattern
IMPORTANT!
This procedure only applicable when 100x100mm mounting holes on back of display are recessed
into back surface of display.
WARNING:
EXCEEDING THE WEIGHT CAPACITY CAN RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer's responsibility to make sure the combined weight of all components
attached to the iCMPDA1 does not exceed 75 lbs (34 kg).
1. Ensure Centris bracket can swivel and tilt easily, yet still be tight enough to hold display in desired position. Adjust as
required before proceeding. See "ADJUSTMENT."
2. Carefully place display face down on protective surface.
CAUTION:
USING SCREWS OF IMPROPER SIZE CAN DAMAGE DISPLAY! Screws should easily and
completely thread into display mounting holes.
3. Place four spacers (R) over mounting holes in display back.
4. Orient mount so that teardrop mounting holes in Centris bracket are aligned with holes in four spacers (R).
WARNING:
INADEQUATE THREAD ENGAGEMENT IN DISPLAY CAN LEAD TO MOUNT FALLING CAUSING
SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT!
5. Using a Phillips screwdriver, install four screws (M) through four teardrop mounting holes in Centris bracket and
spacers (R) into display. Tighten all four screws (M). Do not overtighten!
6. Continue with "INSTALL SWING ARM TO BASE PLATE".
16
5 M x4
R x4
3
4
Installation Instructions
1