JANE QUARTZ Manual De Instrucciones página 16

Pre-adjustments
1
Checking the height of the shoulder belt
To ensure maximum safety for the child, the shoulder belt should pass slightly above the
shoulder. This position will need to be adjusted as the child grows.
1a Place the child in the seat, make sure he is positioned correctly. The belt should go slightly
above the child's shoulder.
1b
To adjust the height, pull the button found behind the headrest (5) and slide the headrest
in the required direction. When it is at the correct height, release the button and move the
headrest to the nearest locking position, it should click into place.
WARNING. Check and adjust this position as the child grows.
!
Choosing where to install the safety seat
Choosing the correct place to install the safety seat in the vehicle can reduce the risk of injury to
the child in the event of an accident. If possible the safety seat should be installed on the back
seat of the vehicle. There are two possible installations:
1. With ISOfix anchors and the 3-point seat belt; follow the instructions in the "semi-universal"
section below. Remember that for this safety seat the ISOfix anchors are only used to give
the seat greater stability, in the event of an accident the child is restrained with the 3-point
seat belt. Also bear in mind that it is "Semi-universal" and not all vehicle seats are compat-
ible, consult the Vehicle List included in a leaflet with the instructions or go straight to our
web page www.jane.es/
2. Just with the 3-point seat belt; follow the instructions in the "Universal" section. In other
words, it is compatible with most vehicle seats. However, whenever the vehicle manufacturer
states that the seats are suitable for "Universal" type car safety seats this means it is fully
compatible.
Raise or remove the vehicle headrest if it interferes with the safety seat headrest.
On seats fitted with a frontal air-bag, move the seat as far back as possible.
16
IM-1751 Quartz 13_10_15.indd 16
Installing your QUARTZ in the vehicle
2
Semi-universal and Universal installation:
Semi-universal:
with ISOfix anchors and the 3-point seat belt
The ISOfix anchors have been designed to safely and easily secure child restraint systems.
Not all vehicles are fitted with these anchors, although they are now generally standard in
newer models. Consult the enclosed leaflet to see the vehicle list stating in which vehicles
the safety seat can be correctly installed. An updated list
If you are going to install your QUARTZ with the rigid anchors, follow the steps below carefully:
2a Pull the anchor out pressing the red buttons on the sides (10).
2b
Make sure that both anchors are open, the red signal should be displayed on the anchor
button (9).
Place your QUARTZ on the vehicle seat in accordance with the advice and warnings contained in
the GENERAL INSTRUCTIONS.
Before installing the safety seat find the ISOfix anchors on the vehicle seat. Once you have found
them, position the QUARTZ so that the rigid anchors (8) are pointing towards the ISOfix anchors
of the vehicle.
2c
Press the rigid anchors towards the vehicle seat until they both lock, check that the green
signal is displayed on the two ISOfix release buttons (10).
2d
Keep pressing firmly until the booster seat touches the backrest of the vehicle seat. Make
sure that it is securely held by pulling the seat.
2e
Place the child in the QUARTZ and make sure that he is sitting well back, pass the seat belt
over him and fasten it
2f
Insert the shoulder belt into the red clip on the headrest (6)
ISOfix
13/10/15 12:09