Checking Tightness; Checking The Electrical Installation; Decommissioning; Recycling And Disposal - Saunier Duval 6 kW Instrucciones De Instalación

1
1 Reset button
► Press the reset button (1).
6.4

Checking tightness

► Check the water-tightness of the system.
6.5

Checking the electrical installation

► Check the electrical installation observing all relevant
regulations.
6.5.1 Checking the cables
► If the power cable of this product is damaged, then to
prevent danger, only the manufacturer, the after-sales
service or similarly qualifi ed persons shall replace the
power cable.
► When replacing the power cable see chapters 4.4 and
4.5.
7

Decommissioning

► Isolate the product from the power mains.
► Drain the appliance (see chapter 6.2).
► De-install the product.
► Recycle or dispose the product and its components (see
chapter 8).
8

Recycling and disposal

► The competent person who installed your product is
responsible for the disposal of the packaging.
If the product is identifi ed with this symbol:
► In this case, do not dispose of the product with household
waste.
► Instead, hand in the product to a collection centre for old
electrical or electronic appliances.
If the product contains batteries that are marked
with this symbol, these batteries may contain substances
that are hazardous to human health and the environment.
0020152773_06 Electric Back-up Heater 6kW Installation manual
DECOMMISSIONING
► In this case, dispose of the batteries at a collection point
for batteries.
9

Technical data

Description
Net Weight
Central heating maximum hydraulic
pressure
(PS max)
H
Central heating minimum hydraulic
pressure
(PS min)
H
Electrical
Voltage / frequency
Maximum absorbed power (P max)
Maximum Current (I max)
Index of electrical protection
Unit
kg 4
bar 3.0
Mpa 0.3
bar 0.5
Mpa 0.05
V~/Hz 230/50
kW 6
A 30
IP X4
EN
49