Cleaning Your Hard Floors - RugDoctor FlexClean FCM-1 Manual Del Usuario

Operations:

cleaning your HARD FLOORS

IMPORTANT CLEANING TIP:
CAUTION
1
To Attach HARD FLOOR NOZZLE
1. Align the nozzle tabs with the slots in the base of
the machine.
2. Rotate NOZZLE 3
toward machine.
3. Latch the
NOZZLE by
pressing down
on the top of
the NOZZLE
until you hear a
"click."
3
Plug In The Machine
Unwrap the POWER CORD
and insert plug into a properly
grounded outlet.
5
Turn Machine On
Push the POWER SWITCH to
"FLOOR CLEANING" position.
7
Cleaning Your Hard Floors
Press the SOAP & SCRUB TRIGGER
to apply solution.
Make 2 slow wet passes
(1 forward, 1 back) over each area.
Release SOAP & SCRUB TRIGGER
approximately 6 inches from stop
point to ensure solution is removed.
12
Sweep area thoroughly before deep cleaning.
Before plugging in machine, check the POWER SWITCH to make sure it is in
the "off" position.
2
1
Press
Soap &
Spray
Trigger
F L E X C L E A N A L L - I N - O N E F L O O R C L E A N E R
®
2
Select
Cleaning
Mode
Turn the FLOW
CONTROL DIAL to
the HARD FLOOR
setting.
4
Position The Machine
Position the machine onto the
desired area to clean.
6
Release The Handle
Step on the HANDLE RELEASE
PEDAL to pull back/release the
MAIN HANDLE.
8
Leave The Machine On
For 15 Seconds
Leave the machine on for 15 seconds
after cleaning to allow for all of the
dirty solution to be collected into
the DIRTY WATER TANK.
Handle
Release
Pedal
| U s e r M a n u a l