Remington i-Light IPL4000 Manual De Usuario página 18

The Bulb Status Indicator Light turns green but the unit does not flash when the
button is pressed.
■ Make sure the Skin Contact Sensor is in full contact with the skin.
■ Try resetting the unit by turning it off and waiting several seconds before turning it
back on.
There is a strange smell.
■ Be sure the area is completely shaved before treatment.
The treated areas become red after treatment.
■ This is normal and the redness should subside. If not, try using a lower light intensity.
I have not seen optimal results or hair has begun to grow back.
■ Hair may begin to grow back after your initial treatment. This is perfectly normal. For
optimal results, repeat the treatment when you notice hair regrowth.
Intensity/Flash Mode LED
All currently selected
LEDs flashing
Intensity LEDs flashing
in sequence
All LEDs flashing with
warning beep
Audible Tones
Not Full Contact
Replace Light Cartridge
Contact Sensors Stuck
090597_REM_IFU_IPL5000_7L GB17 090597_REM_IFU_IPL5000_7L GB17
Indication
Unit is overheated and is disabled momentarily to cool down.
Unit is malfunctioning. Turn the unit off, wait a few moments and try
again. If problem persists, the unit should be returned for repair.
Nose cone is removed or loose.
Indication
Flash button was pressed while the skin contact sensor was not
fully engaged.
Light cartridge is missing or needs to be replaced.
Flash button was pressed after the contact sensor had been
engaged since unit start up. Contact sensor may be stuck.
17
23.07.09 22:03 23.07.09 22:03