Fuse Replacement - Facom B12OBD.M Guía De Instrucciones

WARNING: Do not connect the 12V power plug of the B12OBD.M into the power
outlet within the same vehicle from which you are removing the battery.
4. Connect the OBD diagnostic connector to the vehicle's OBD plug. Make sure the
connector is fully engaged. The yellow CONNECTED LED in box #2 will light,
indicating a good connection.
5. Verify that the green LED in box #3 is lit, indicating you may disconnect the vehicle's
battery. If the red LED in box #3 lights, do not disconnect the vehicle's battery;
disconnect the B12OBD.M and check the internal fuse or contact a qualifi ed
service personnel for electrical system repair.
6. Disconnect the vehicle's battery cables and cover the positive and negative cables
with an insulator, such as electrical tape. This prevents the connectors from touching
metal, each other, or the chassis and causing a short circuit, due to the vehicle's
electrical system receiving power through the OBD connection.
Warning: When working with the vehicle's battery, review all of the battery manufacturer's safety
instructions, warnings and directives regarding battery disconnection, removal and replacement.
7. Remove the old battery and put the new battery into position.
8. Remove the insulator from the positive cable and connect it to the positive terminal of the new battery.
9. Remove the insulator from the negative cable and connect it to the negative terminal of the new battery.
10. Once the new battery is connected, unplug the memory saver's OBD connector from the vehicle's OBD
plug and disconnect the 12V DC plug from the 12V power supply.
The 12V power plug adaptor operates with a supplied 5A 250V glass fuse.
1. Access the fuse compartment by turning the tip of the adaptor in a counterclockwise direction.
NOTE: The fuse is spring-loaded and caution must be taken to ensure that the spring does not "fl y out" of
the end of the fuse compartment when it is opened.
2. Remove the fuse and replace it with one of the same type and rating.
3. Close the adaptor by turning the tip in a clockwise direction.
NU-B12 OBD.M_1017LD.indd 5

FUSE REPLACEMENT

5
09/10/2017 14:48:46