Pleasant Hearth FA183S-P Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
1. Attach the two feet (B) to the front of the screen
(A) by inserting four M6x35mm bolts (AA)
through the pre-drilled holes in the feet (B) and
through the screen frame (A). Secure with four
M6 nuts (BB). Use a wrench (EE) to hold the
bolt (AA) in place while using the other wrench
(EE) to tighten the nut (BB). Repeat for all 4
bolts (AA)/nuts (BB).
Hardware Used
AA
M6x35mm Bolts
BB
M6 Nut
EE
Wrench
2. Attach the back feet (C) to the back side of the
screen (A) by inserting one M6X20mm bolt (CC)
into the hole in each foot (C) as illustrated
in figure 2. Adjust feet (C) to desired width.
Tighten against the screen (A) using
the wrench (EE).
NOTE: The back feet are designed to adjust to
the inside width of your fireplace opening so
that, if desired, the screen can be placed flush
against the fireplace.
Hardware Used
CC
M6x20mm Bolts
EE
Wrench
3. Attach the handles (D) to the screen (A) by
inserting the M5x20mm bolts (DD) through the
pre-drilled holes in the screen and through the
handles (D) as shown in figure 3. Tighten
using a Phillips screwdriver.
Hardware Used
DD
M5x20mm Bolts
1
BB
x 4
x 4
x 2
2
x 2
x 1
3
A
x 4
4
A
B
AA
A
C
CC
D
DD