Mount Cover Plate - Honeywell THP2400A1019 Guia De Instalacion

THP2400A1019 COVER PLATE ASSEMBLY
CAUTION
Electrical Hazard.
Can cause electrical shock or equipment damage.
Disconnect power before beginning installation.

Mount Cover Plate

Mount Cover Plate Directly to Wall (See Fig. 2)
1. Pull the wires through the wire hole on the cover plate and wall plate.
2. Position the cover plate and wall plate on the wall with the arrows pointing up. Level the wall plate for appearance
only.
3. Use a pencil to mark the mounting holes for your thermostat.
4. Remove the cover plate and wall plate from the wall and drill two 3/16-in. holes in the wall (if drywall) as marked.
For firmer material such as plaster, drill two 7/32-in. holes. Tap the wall anchors (provided with the thermostat)
into the holes, until the anchor collar touches the wall.
5. Pull the wires through the wire hole on the cover plate and wall plate. Position the cover plate and wall plate on
the wall anchors.
6. Insert the mounting screws (provided with the thermostat) into the wall anchors. Check leveling, if desired, and
tighten the mounting screws.
WALL OPENING
WALL ANCHORS (2)
(PROVIDED WITH
THERMOSTAT)
WIRE
69-2762EFS—01
Fig. 2. Mount cover plate, wall plate and thermostat directly to wall.
COVER PLATE
WIRE HOLE
MOUNTING HOLES (2)
WALL PLATE
2
WIRE HOLE
MOUNTING HOLES (2)
MOUNTING SCREWS (2)
(PROVIDED WITH
THERMOSTAT)
THERMOSTAT
M34259