Connecting The Sensor Or Sensors To The Measuring Instrument And Starting Up - WEBTEC CT-CAN Serie Manual Del Usuario

3.6 Connecting the sensor or sensors to the measuring instru-
ment and starting up
Using a connection cable, the individual sensor or sensor bus system
should be connected to one of the CAN ports on the measuring instru-
ment.
After the measuring instrument is turned on, the sensor is automatical-
ly detected and initialized. The start screen appears on the display after
this process has ended. The LED signals on the CAN sensors are used
for identification and status display.
► Additional information about the LED signals can be found in the
"LED signals on the sensor" table.
After the boot-up process, you can make further setting changes on the
measuring instrument or you can begin measuring.
► Additional information about operating the HPM6000 measuring in-
strument can be found in the instrument's operating instructions.
32