IMPORTANT SAFETY INSTRUCTIONS
SAFETY ALERT SYMBOL
The symbol above is used to call your attention to
instructions concerning your personal safety. It points out
important safety precautions. It means "ATTENTION!
Become Alert! Your Personal Safety is involved!" Read
the message that follows and be alert to the possibility of
personal injury or death.
DANGER
A person who has not read and understood all operating
Instructions is not qualified to operate this product.
DANGER
Do not immerse heater in liquid.
Keep volatile or combustible material away from
heater when in use.
Use heater only in approved locations.
Keep sharp metal objects away from heater.
Failure to observe these warnings may result in electric
shock, risk of fire, and personal injury.
WARNING
End-User Must Comply to the Following:
Only qualified personnel are allowed to connect
electrical wiring.
Disconnect all supply power at the source before
making any power connections.
All electrical wiring must follow local electrical
codes and highly recommend following NEC
Article 427.
The person who performs the final installation /
wiring must be qualified for this work.
The end-user is responsible for providing a
suitable disconnecting device.
The end-user is responsible for providing suitable
electrical protection device. It is highly
recommended that a ground fault circuit breaker
be used.
Failure to observe these warnings may result in personal
injury or damage to the heater.
®
© BriskHeat
Corporation. All rights reserved.
Silicone Rubber Beaker Heater
DANGER
Immediate hazards which WILL result in severe personal
injury or death.
WARNING
Hazards or unsafe practices that COULD result in severe
personal injury or death.
CAUTION
Hazards or unsafe practices that COULD result in minor
personal injury or property damage.
CAUTION
Never handle the heater while it is in operation;
always disconnect the heater from the power
source and allow to cool prior to handling.
Inspect heater before use.
Never operate heater without a temperature
control device.
Do not wrap the heater over itself. Only hook and
loop closure mating surfaces are intended to
overlap.
If spillage of foreign matter onto heater occurs,
disconnect from power source and clean after
heater is allowed to cool.
Never operate a heater without an appropriate
heat sink (device being heated is considered a
heat sink).
Do not operate heater above rated temperature
value.
Fasten heater to device using approved methods
only.
Do not repair damaged or faulty heaters.
Do not crush or apply severe physical stress on
heater or cord assembly.
Disconnect heater when not in use.
Failure to observe these warnings may result in personal
injury or damage to the heater.
3
SPECIFICATIONS
Maximum exposure temperature:
450 °F (232 °C )
120, 230, or 240 VAC
2
2
Power density: 0.8 W/cm
(5.0 W/in
)
Heating element is laminated between
two layers of 15mil fiberglass reinforced
silicone rubber
1 in (25 mm) wide hook and loop fastener
Moisture, chemical, and radiation resistant
Dielectric strength of over 2000 volts
24 in (610 mm) long power leads with
120 VAC: Standard 2-prong NEMA 1-15 plug
230 VAC: Crimped Ferrule Wire Connection
240 VAC GBHE: Crimped Ferrule Wire with Grounded Wire Connection
GBH Series:
Heater
Heater
Size
Diameter
Height
Width
ml
in (mm)
in (mm)
In (mm)
250
2.7 (69)
3.0 (76)
12.25 (311)
400
3.0 (76)
3.5 (89)
13.75 (349)
600
3.6 (91)
4.0 (102)
15.00 (381)
1000
4.3 (109)
4.6 (117)
17.25 (438)
GBHE Series:
Heater
Heater
Size
Diameter
Height
Width
ml
in (mm)
in (mm)
In (mm)
250
2.7 (69)
3.25 (83)
12.25 (311)
400
3.0 (76)
3.5 (89)
13.75 (349)
600
3.6 (91)
4.0 (102)
15.00 (381)
1000
4.3 (109)
4.6 (117)
17.25 (438)
®
© BriskHeat
Corporation. All rights reserved.
Silicone Rubber Beaker Heater
Total
Part Number
Part Number
Watts
120 VAC
230 VAC
150
GBH0250-1
GBH0250-2
200
GBH0400-1
GBH0400-2
250
GBH0600-1
GBH0600-2
350
GBH1000-1
GBH1000-2
Total
Part Number
Part Number
Watts
120 VAC
240VAC
N/A
150
GBHE0250-2
N/A
200
GBHE0400-2
N/A
250
GBHE0600-2
N/a
350
GBHE1000-2
4