Directions For Use - EASY FAST CIH000019NOC Manual De Instrucciones

Máquina de coser portátil
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

8
HANDHELD SEWING MACHINE

DIRECTIONS FOR USE

Note: Operate the machine for 10 seconds ,and then pause for 5 seconds.lt can
then be used again regularly. I.Make sure machine is in the locked position (see
diagram on reverse side under «To Replace Batteries»).
Raise the needle arm to the highest position by turning the rotary wheel .Note :The
rotary wheel can be turned in either direction (see diagram #1)
2. Lift up the fastening plate making sure not to push down on the needle am (the
arm can still be moved manually even when the machine is in locked position
).Place cloth underneath the fastening plate (see diagram #2).
3. Pull at least 2 inches of thread through the needle .from back to front .prior to
starting to sew .
4.Hold the Handy Stitch with right hand and operate power switch with thumb .other
fingers supporting the bottom (see diagram #3).
dia. #4
5.Unlock machine (see diagram on reverse side under «To replace Batteries
n).Press the power switch with your right thumb.The machine will feed cloth to the
left in proper tension automatically ,use left hand to hold the cloth and control the
direction(do not rush machine).when wider stitches are required ,pull cloth to the
left a little faster while you continue sewing .Follow the centerline on cloth fastening
plate to ensure straight stitching (see diagram #4).
6.1b Finish Seam -When working sewing .raise the needle arm to the highest
position by turning the rotary wheel .The use the back of a seam ripper or scissors
to pull the thread out about 3 inches the cut it (see diagrams 5 and 6).
7. Turn the rotary wheel .lowering the needle into the cloth &continue to turn the
rotary wheel until the needle arm is again at its highest position.
8. Lift up the fastening plate and take off the cloth to the left .making sure not to pull
the thread or the seam will unravel.
9.Turn to back side of the cloth and guide the reserved 3 inches of thread according
to the following figure to make the knot (see diagram to the right):
1.
First pass threader through the last stitch.
2.
Put the thread into threader.
3.
Pull out about 1 inch
4.
Guide the thread through the loop and pull it tight to finish the knot.

Publicidad

Tabla de contenido
loading

Tabla de contenido