Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE THE REMOTE CONTROL
Press and hold the button down until the door or gate starts to move. The
remote control will operate from up to 3 car lengths away on typical
installations. Installations and conditions vary, contact an installing dealer for
more information.
BATTERY
The LED(s) on your remote control will stop flashing when the battery is low and needs to be replaced. To
replace battery, open the case as shown. Insert battery positive side up (+). Replace the battery with only
3V CR2032 coin cell batteries. Dispose of old battery properly.
Pry open the case fi rst in the middle (1), then at each side (2 and 3) with the visor clip.
WARRANTY
ONE YEAR LIMITED WARRANTY
The Chamberlain Group, Inc. warrants to the first consumer purchaser of
this product that it is free from defect in materials and/or workmanship for a
period of 1 year from the date of purchase.
Remote control 893MAX-LMK: IFT #: RCPME8917-2062
"Operation of this equipment is subject to the following two conditions: (1) This equipment or device may
not cause harmful interference, and (2) This equipment or device must accept any interference, including
that which may cause undesired operation."
Brand: Merik
Models: 893MAX-LMK
Description: Remote Control
Use 1 3Vdc CR2032 Battery
Country of origin: Mexico
3V CR2032
3
1
2
Additional buttons on the remote control can be programmed to operate up to
3 devices such as additional garage door openers, light controls, gate
operators or access control systems.
To prevent possible SERIOUS INJURY or
DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify
To reduce risk of fire, explosion or chemical
burn:
• Replace ONLY with 3V CR2032 coin
NOTICE: To comply with FCC and or Industry Canada rules (IC),
adjustment or modifications of this receiver and/or transmitter
are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.
Tested to Comply with FCC Standards for Home or office use.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
REPLACEMENT PARTS
3V CR2032 Lithium Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10A20
Visor Clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29B137
doctor.
batteries.
•
DO NOT recharge, disassemble, heat
above 212° F (100° C) or incinerate.
Publicidad
