Nostalgia Products CBD5SS Manual De Instrucciones página 9

BASIC ASSEMBLY
1
Fit the Tap Handle
onto the Tap Faucet.
KEG LIFTER ASSEMBLY
Once you have determined the type of keg you will be tapping,
correctly secure the Keg Lifter Assembly to the keg.
Keg Lifter
5L Standard Non-Pressurized Kegs
1. Follow any required instructions marked on the keg to
eliminate excess gas, and to ensure the keg has rested
long enough to avoid foam coming out of the Tap Faucet.
2. Place the Keg Adapter (square) into the top opening
of the Keg Lifter, then screw the Dip Tube into the
bottom of the Beer Line Connector. When done
correctly, this will secure all three pieces together.
3. Pierce the seal on the top of the keg and
place the Keg Bung into the opening.
4. Insert the Dip Tube into the Keg
Bung and fully into the keg.
5. Secure the ends of the Keg Lifter onto the lip of the keg.
7
2
Slide the notches on
the Drip Tray into the
tabs located at the
bottom of the main unit
Keg Adapter
(circle)
Pressurized
Keg Bung
Keg Adapter
3
Make sure the Drain Tab
is in the closed position,
like shown above.
Dip Tube
Keg Adapter
(square)
Keg Adapter
(square)
Keg Lifter
Dip Tube
Keg Bung
Keg