BLACK&DECKER BDGL1200 Manual De Instrucciones página 11

90504494 02 BDGL1200 drill
USING THE LASER LEVEL FUNCTION (HORIZONTALLY LEFT - FIGURE L)
• Place the tool flat against the wall as shown.
• Slide the laser on/off switch (6) to position I to switch the laser ON.
• Move the laser direction actuator (7 in Figure K) to the left most position. Laser will
project horizontally to the left from the laser aperture (5 in Figure B).
• Move the tool as necessary to position the laser line.
NOTE: The laser lines will only be level if the tool is kept within 5 degrees from
vertical.
• Slide the laser on/off switch (6) to position 0 to switch the laser OFF.
NOTE: Laser will not work if the drill is inverted.
USING THE LASER LEVEL FUNCTION (VERTICALLY - FIGURE M)
• Place the tool flat against the wall as shown.
• Slide the laser on/off switch (6) to position I to switch the laser ON.
• Move the laser direction actuator (7 in Figure K) to the center position. Laser will
project vertically from the laser aperture (5 in Figure B).
• Move the tool as necessary to position the laser line.
NOTE: The laser lines will only be level if the tool is kept within 5 degrees from
vertical.
• Slide the laser on/off switch (6) to position 0 to switch the laser OFF.
NOTE: Laser will not work if the drill is inverted.
USING THE LASER LEVEL FUNCTION (HORIZONTALLY RIGHT - FIGURE N)
• Place the tool flat against the wall as shown.
• Slide the laser on/off switch (6) to position I to switch the laser ON.
• Move the laser direction actuator (7 in Figure K) to the right most position. Laser will
project horizontally to the right from the laser aperture (5 in Figure B).
• Move the tool as necessary to position the laser line.
NOTE: The laser lines will only be level if the tool is kept within 5 degrees from
vertical.
• Slide the laser on/off switch (6) to position 0 to switch the laser OFF.
NOTE: Laser will not work if the drill is inverted.
SCREW DRIVING
For driving fasteners, the reversing button should be pushed to the left. Use reverse
(button pushed to the right) for removing fasteners. When moving from forward to reverse,
or vice versa, always release the trigger switch first.
ON BOARD BIT STORAGE
A bit storage slot is built-in to the area just above the battery pack.
DRILLING
• Use sharp drill bits only.
• Support and secure work properly, as instructed in the Safety Instructions.
• Use appropriate and required safety equipment, as instructed in the Safety Instructions.
• Secure and maintain work area, as instructed in the Safety Instructions.
• Run the drill very slowly, using light pressure, until the hole is started enough to keep the
drill bit from slipping out of it.
• Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting
but not so much as to stall the motor or deflect the bit.
• Hold the drill firmly with two hands to control its twisting action.
• DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND ON IN AN ATTEMPT
TO START IT. DAMAGE TO THE DRILL CAN RESULT.
• Minimize stalling on breakthrough by reducing pressure and slowly drilling through the
last part of the hole.
• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce
jamming.
• Make sure switch turns drill on and off.
8/29/06 8:39 AM Page 11
11