Connecting To The Power Supply - Trevi SB 5010TV Guia Del Usuario

ENGLISH SB 5010TV
INSTALLATION
Use the Sound Base as the basis for a television (TV Max.30Kg for up to 55 ").

CONNECTING TO THE POWER SUPPLY

Fit the plug into an AC 220/240V - 50/60Hz socket. Do not plug the appliance to different power.
Unless otherwise specified, the controls description applies to both the appliance and the remote control.
POWER ON/ STANDBY AND AUTO POWER FUNCTION
1. Press the power-on/standby ON/OFF key (1) to switch on the device.
2. Press the power-on/standby ON/OFF key (1) again to switch the device back to standby mode.
This device is equipped with Auto Power On/Off function; this function allows the automatic power on off Sound Bar in the presence of an audio signal
on one of the input and automatic shutdown when no audio signal inputs after 15 minutes.
Note: If the Sound Base does not react to any operation or does not work properly, disconnect the power cable for 30 seconds to reset the device.
VOLUME ADJUSTMENT AND MUTE FUNCTION
It's possible to adjust the volume of the unit with the volume keys (4 on the device, 3 on the remote control)
1. Press the + button to increase the volume of the device.
2. Press the - button to decrease the volume.
Note:
When connecting to the headphone output of a TV or a device that has its own speakers, these usually are disabled and to have a good output signal
need to adjust the volume to the maximum level through the commands of TV (or device).
When connecting to the audio output of a TV-Scart (or any audio output that is not the headphone jack of another device), the level of the sound
output is constant and not adjustable via the command own the TV (or device); the speakers of the TV (or device) is not disabled and if you want to
silence them need to lower the volume completely otherwise the reproduction is in addition to the Sound Base.
MUTE: To activate the mute function of the device via the MUTE button (7) on the remote control (the display shows MUTING); to reactivate listening
press the MUTE button.
Note:
- Some audio outputs which you connect the Sound Bar (like headphone output) can have its own volume control: make sure you have set on the
source device an adequate level audio output otherwise the Sound Base will sound even at maximum volume.
- If the sound played by the Sound Base be distorted means that the input signal is too strong: lower the volume of the Sound Base or paid on a level
audio source device output more low.
AUX
1. Use a cable with RCA Stereo jack to connect the AUX (9) to the headphones / audio of the TV or other source device.
2. Turn on the unit and press the SOURCE button (2) to select the AUX input.
3. For proper playback sound refer to chapter VOLUME ADJUSTMENT AND MUTE FUNCTION
(Not included)
6