Assembly Instructions - Endless Summer 153100 Manual Del Propietário

Contact 1.800.762.1142 for assistance. Do not return to place of purchase.

Assembly Instructions

DO NOT RETURN PRODUCT TO STORE.
For assistance call 1.800.762.1142 toll free . Please have your owner's manual and serial
number available for reference .
For Easiest Assembly:
• To avoid losing any small components or hardware, assemble your product on a hard level
surface that does not have cracks or openings .
• Clear an area large enough to layout all components and hardware .
• When applicable, tighten all hardware connections by hand first . Once the step is
completed go back and fully tighten all hardware .
• Follow all steps in order to properly assemble your product .
To complete assembly you will need:
• (1) Leak Detection Solution (Instructions on how to make solution are included in step
Operations Section)
• (1) Precision Filled LP Gas Grill Tank with Acme Type 1 external threaded valve connection
(4-5 gallon size)
Note: You must follow all steps to properly assemble heater .
Typical assembly: approximately 1 (one) hour .
Step
Attach Legs to Base
1
Note: Attach Leg with notches for hinges as shown at left .
A . Attach legs to base using 6 sets of large bolt (G), lock washer (M), and large nut
(K) . Finger tighten only .
Note: Do not fully tighten until Step 2 .
Step
Attach back shroud panel
2
A . Attach back shroud panel to legs using 6 large screws (D) .
B . Tighten nuts and bolts from Step 1 .
Step
Assemble cap
3
Attach cup, ring, brace, and gas line clip to shroud cover using 3 large bolts (G) .
Step
Attach cap assembly and gas line
4
Note: Do not fully tighen screws until all screws are in place .
A . Attach cap assembly to shroud and legs using 3 large screws (D) .
B . Insert gas line through cap assembly .
Step
Assemble emitter top
5
Attach 3 sets of small bolts (F), lock washer (M), and large nut (K) .
page no .
3