Kalorik STP 30138 Manual De Instrucciones página 8

Fax +32 2 359 95 50
USING THE SPRAY BOTTLE
Lightly spray the garment with the spray bottle (16) before placing it
on the ironing board. This helps to distribute an even, fine mist over
the fabric, preparing it to be pressed, and removing all wrinkles.
USING THE PRESSING CUSHION
Some garments have been constructed with details, such as darts,
curved seams and shoulder pads, which are not intended to be
pressed flat. A pressing cushion is supplied with your steam press for
use with these areas.
Use the cushion (15) whenever pressing areas where no creases
•
are desired or to shape tailored garments.
Place the area to be pressed onto the ironing board.
•
Place the pressing cushion under the dart, seam etc.
•
Make sure the area to be pressed is raised and lower the pressing
•
plate. The raised area is the only area the plate should contact.
NOTE: Do not attempt to lower the pressing plate to its lowest position
or lock the pressing plate against the ironing board with the pressing
cushion in place. You MAY DAMAGE the steam press by doing so.
Raise the pressing plate after a few seconds.
•
FINISHING PRESSING / STORAGE
Water may be left in the water tank, because it will not drip out if
•
the machine is stored in an upright position. However, it is very
recommended that if the machine will be stored for some time,
that all the water in the unit should be drained by pressing the
burst of steam button until all of the water is pumped out.
Press the "ON/OFF" button, the red power light will start blinking.
•
Disconnect the plug from the wall outlet. Leave the appliance in
open position.
Wait for the steam press to cool completely (approximately 30
•
minutes).
When cool, lower the pressing plate onto the ironing board
•
pushing the handle to its lowest position.
Turn the locking knob to the "Lock" position. This should prevent
•
the steam press from opening while being moved or stored.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
8
Assembly page 8/35
special instruction from Team
Print only
STP 30138 - 120501