Solvis DeltaControl Manual Del Usuario página 12

DeltaControl – Operation
EN
Readouts in the Display
Read-
Meaning
out
"Basic settings" menu
is active
(rotating) Output A1
(solar pump) on
Temperature sensor 1
(collector)
Temperature sensor 2
(bottom of the storage tank)
Frost protection activated
"System Diagram" section, p. 11
Readout Meaning
T max Maximum permitted storage tank temp.
dT max Storage tank switch-on temp. diff. (T1-T2) 3...40 K
dT min Storage tank switch-off temp. diff. (T1-T2) 2...35 K
T min Min. value, A1 off if T min > T1
on Manual on/off switching of pump A1
RES Reset to factory settings
V1.1 Firmware version
"Info" menu
Operation
The controller has a microbutton
p. 11, that is operated through a small
hole in the right side of the housing using
a suitable tool.
When you press the microbutton, the con-
troller display switches from the "Info"
menu to the "Basic Settings" menu. You
can select the variables and information
required (see table above) by repeatedly
pressing the button.
To change the selected variable, press
12
All readouts in the display
1
the button for approx. 2 seconds until the
, see
value flashes. Then press the button to
increase the value. The value increases
with each press of the microbutton until it
reaches the maximum value in the range
and then jumps back to the minimum
value in the range.
To save a value, press the microbutton
again for approx. 2 seconds. The con-
troller will jump back to "Info" mode after
pressing the microbutton for approx. 10
seconds.
N 15-M – Subject to technical changes 02.17
stopstart
dTminmax
X
Value range Factory setting
+15...+95°C 80°C
10 K
5 K
+5...+90°C 10°C
0/1 = off/on 0 = off
– –
– –
– –