monolith Extra Montaje página 12

monolith EXTRA
7 Aligning the side sections
8 Aligning the top plate holder
9 a) Fitting the top plate
12
Using a spirit level, check that the upper
edge of the side elements is at the same
height as the top of the steel casing.
Ensure that you do not scratch
the carcass.
Adjust the top plate screws until there is
a 2 cm gap between screw and top edge
of stone element.
Ensure that you do not scratch
the stone.
Now carefully place the top plate onto
the screws.
Ensure that you do not scratch
the top plate during this oper-
ation.
English