Publicidad
May we congratulate you on your new greenhouse
GB
Dear Customer!
DEAR CUSTOMER
Congratulations on purchasing your new
The assembly of your new house requires
greenhouse. It is important that you follow these
a bit of technical knowledge. However, it is
assembly instructions step-by-step.
important that the assembly instructions are
followed strict-ly. The assembly instruction
The assembly instructions are a combination of text
is a combination of text and illustrations. The
and illustrations. The profiles are packed in separate,
profiles are packed in separate numbered packs
numbered packs corresponding to their order of use
in the instructions. Assemble one pack at a time. All
corresponding to the order in the assembly
nuts, bolts and fittings are contained in one box.
instruction. Erect one pack at a time. All nuts
Each pack is specified on separate lists of
and bolts and fittings are found in bag No. 0
components.
(specified on page 12). Each pack is specified in
separate lists of components.
All detailed illustrations are marked with the
All detailed illustrations are marked with
following symbols:
symbols:
Seen from inside
Seen from outside.
Seen from the inside
Seen from the outside
SOME SAFETY PRECAUTIONS
Precautions.
•
Only carry out assembly in dry and calm
•
Assembly must only be carried out in dry
weather
and calm weather.
•
Always wear work gloves when installing the
•
Always use working gloves while glazing.
glazing. Greenhouse glass has sharp edges,
Greenhouse glass has sharp edges,
especially if it breaks
especially if the glass breaks.
•
Assistants and especially children must be
•
Assistants and especially children must be
warned that broken glass presents a safety
hazard. Pick up all broken glass at once and
warned that broken glass is an element of
remove it with care
danger. Pick up broken glass at once and
•
Any ladders used must be placed on a level
remove it with care.
surface.
•
We recommend to use protective glasses
•
Make sure you have an assistant to help you.
while fixing the spring wire clips.
•
Place the ladder on a level support.
PAGE 12: TOOLS
•
It is essential to have an assistant.
Assembling the greenhouse requires the tools
shown on page 12.
References
PAGES 14-15: BASE
The column marked
indicates the
No base is included with this product. However, an
page(s) on which the component is used.
original base can be purchased separately. This base
is easy to construct and will guarantee you a stable
Page 13:
base for your greenhouse.
Foundation
The base is not included in this delivery.
If you construct your own base, the specified
However, an original base can be bought
dimensions must be external dimensions.
separately. It ensures you a stable and easy to
Anchor holes must be deep enough to extend below
build base.
the frost line (800mm). Place the assembled base
If you make your own base the measurements
with anchor legs over the holes so the anchor legs fit
indicated must be external measurements.
into the holes; it takes about 75-90 litres of concrete
If you buy an original base you furthermore
to fill up the holes.
need about 75 litres of concrete and 6/8
Make sure the base is completely level and square.
plastic-/concrete pipes of about 800 mm which
To square the base, make sure the two diagonal
are placed in a non-freezing depth for the
measurements are identical (see page 14).
fastening of the corner and middle anchors.
The base must be 100% level and square; the
PAGE 16-33: ORDER OF ASSEMBLY
latter is ensured by checking that the two
Position the components as shown on the
diagonal measurements are equal.
illustration and assemble in the order shown on the
pictures. Do not fully tighten the nuts until the entire
Tools
subassembly has been assembled.
The mounting of the greenhouse requires the
tools shown on page 12.
PAGE 26-29: DOORS AND WINDOWS
For easier assembly, we recommend that you oil the
screws for the door. Window glass must be fitted
Page 14-27:
at the same time as the profiles. Glass for the door
Place the components as shown on the
must be fitted after assembly of the door.
illustration and assemble in the order shown
in the pictures. Do not tighten the nuts
completely until the front gable construction
has been assembled.
PAGES 30-33: FITTING OF GLASS
Page 13:
Important before assembly!
(Fastening to the base).
Make sure that the gables and sides are level and
When constructing your own base you have
square and that door(s) and window(s) open and
to drill holes (7 mm) in the ground frame
shut perfectly.
between all the vertical frames, the greenhouse
is then fastened to the base with screws (A).
Using an original base the greenhouse is
The best order of assembly for the glazing is as
fastened to each vertical bar as shown on
follows:
drawing B/C.
Windows – Roof – Doors – Gables – Sides
Page 24-27:
PAGE 30-33: GLASS INSTALLATION
For an easier assembly we recommend that you
Apply 411-82 to profiles marked with a dotted line
oil the screws for the doors.
on the illustration. Fit one piece of glass at a time.
Fitting of glass/polycarbonate
GR strips are fitted as shown on pages 30-31.
Important before glazing!
Place the upper part of the strip under the
aluminium profile along the full length of the sheet
and then click the strip into position from above.
Make sure that gables and sides are level and
square, and that door(s) and window(s) are
functioning perfectly.
Best order of assembly:
1) Windows – 2) Roof – 3) Doors – 4) Gables
– 5) Sides
Page 30-33:
Glazing (illustration 1 to 8)
Degrease the sheets and frames with spirit.
Start glazing from below, one glass at a time.
Apply a 3 mm silicone line on the vertical
frames where indicated (dotted lines on
the illustration). (A 3 mm line of silicone is
sufficient to obtain maximum attachment). If
you do use more than recommended, you can
buy extra tubes.
Spring wire clips and glassholders are to be
fitted as shown.
X = Spring wire clips, > = Glassholders
In case of broken glass carefully pull it
outwards and loosen the silicone by means of a
sharp craft knife.
Clean the profile completely before inserting a
new pane of glass.
Page 34-37:
Mounting of polycarbonate
The illustrations at the bottom of page 34/36
show where to mount the polycarbonate plates
and lists. The type indication states the length
in mm. A possible adjustment is made by
means of a fine-tooth saw.
NB! To avoid the formation of algae the
polycarbonate sheets must not come into
contact with the ground. Rest them on a piece
of cardboard.
A-lists are mounted as shown on page 35/37.
Put the sheet into the bottom list, bend the
sheet slightly outwards and put it in the top list.
M-lists are mounted as shown on page 35/37.
Place the upper part of the list under the alu.
www.hallsgreenhouses.com
profile in the whole length of the sheet and
hereafter click on the list from above.
Please refer to website for the most up to date instruction
Your greenhouse is now fully assembled. However,
Sealing of the polycarbonate sheets
please note the following:
The sheets may be sealed against insects.
Close the top end off with alu-tape or silicone.
MAINTENANCE
The bottom only with airstrip tape to let
•
condensation out (available at your local
•
dealer).
•
•
•
Now your greenhouse is completely assembled.
However, please notice the following:
WINTER PROTECTION
Maintenance
If you anticipate snow during the winter, we
•
recommend the following winter precautions:
•
•
•
•
•
•
•
•
•
Winter Protection
In areas with occurrence of snow we
recommend the following winter protection:
WATER AND CONDENSATION
•
Please note that your greenhouse is not like a
conservatory, for example, and that you should
therefore be aware that the greenhouse may leak
•
during or after precipitation and that condensation
•
will occur on the inside of the greenhouse. Good
ventilation will help prevent condensation.
•
INSURANCE
•
Please note that not all insurance companies cover
greenhouses automatically. Please contact your
insurance company to ensure that your greenhouse
is covered.
Insurance
Please note that not all insurance companies
GUARANTEE
cover glasshouses automatically. Please
Juliana greenhouses come with a 12-year guarantee,
contact your insurance company to ensure an
covering the replacement or repair of faulty parts.
insurance coverage.
The guarantee does not cover polycarbonate, glass,
transport, assembly, freight, etc.
Guarantee
Juliana greenhouses come with a two-year
Juliana grants a guarantee of 12 years which
guarantee, covering painted parts, if any. Please
note that suspension of the profiles may leave marks
covers replacement of faulty parts. The
in the paint.
guarantee does not cover polycarbonate, glass,
The guarantee will become void if the greenhouse is
transport, assembly, freight etc.
not assembled in accordance with these instructions
Juliana grants a guarantee of 2 years on painted
parts, if any. Note that marks in the painting
COMPLAINTS
may occur due to suspension of the profiles.
All our greenhouses are built to the highest quality
The guarantee is invalid if the greenhouse is
standards. However, should you find any defects,
not assembled according to these instructions.
please contact your dealer immediately. When
describing the defect, please state the greenhouse
model and component number.
Complaints
All our greenhouses are built to high standards
Suspension marks and unpainted ends on painted
of quality. However, should a complaint
profiles, if any, will not be visible after assembly of
occur please contact your dealer at once.
the greenhouse.
Remember to specify the defect by indicating
the greenhouse model and number of the
Congratulations on your new greenhouse! We hope
component and the quality control number.
it will bring you many years of gardening pleasure.
B
USA
Grease the doors (hinges and locks).
Keep the gutters free from leaves, etc.
Adjust the windows as necessary.
Replace any broken glass.
Clean the greenhouse with disinfectant before
and after the growing season.
Grease doors (hinges and lock).
Clean the gutter for leaves, etc.
Support the apex of the roof in the middle.
Adjustment of windows.
Remove any deep snow from the roof.
Replacement of broken glass.
Take precautions to prevent snow falling from
a tree or roof, for example.
Clean the house with disinfectant before
Remove the cylinders for the automatic
and after the growing season.
window openers, if fitted (optional extras).
Secure the door(s) and window(s) to prevent
wind damage to the greenhouse.
Support the roof ridge at the centre of the
house.
Remove greater snow loads from the roof.
Take precautions against snow falling
down from for instance a tree or a roof.
Dismount the cylinders for the automatic
window openers, if any (optional extras).
Secure door(s) and window(s) preventing
wind damage to the house.
Publicidad
