Maintenance And Storage - Lanaform Safety Handle Manual Del Usario

• Use the SAFETY HANDLE exclusively for its purposes, as described in this
manual.
DESCRIPTION OF THE DEVICE (see diagram on page 2)
1. Suction force levers
2. Safety signals (suction force)
3. Suction discs (suction devices)
4. Rotation of 2 handles
INSTRUCTIONS FOR USE
Instructions for use:
1. Clean the chosen flat surface with a cleaning product and let it dry.
2. Check the proper functioning of the device. Turn the three suction force levers
to the on position (figure 1). Then position the SAFETY HANDLE in the desired
location. Hook each suction disc separately (figure 2) while being sure to
properly compress the disc before pushing the lever down.
3. Do not place the handle on mortar or tile joints (figure 3).
4. After setting the handle, the safety indicators must be green (figure 4). The
suction force should then be noticeably strong; please check to make sure it is
(figure 5).
Principles:
- When the safety indicators are GREEN, the handle has been attached properly.
- When the safety indicators are RED, the handle has not been attached pro-
perly and must be refastened.
How to remove the SAFETY HANDLE:
1. Turn the three suction force levers to the off position (figure 6).
2. There may be some suction force present. If this is the case, lift a suction disc
by the strip with your fingers (figure 7).
3. Leave the levers in the off position until the next time you use the SAFETY
HANDLE.

MAINTENANCE AND STORAGE:

Clean the device with a soft and damp cloth. Use cleaning devices that are non-
abrasive in order to prevent damaging the device.
Store this device in a dry place and make sure that the three levers are in the
off position.
EN
5