TRUSST CT-TENT Guía De Referencia Rápida página 2

TRUSST® QRG
About This
Guide
Disclaimer
Safety
Notes
Contact
The TRUSST Quick Reference Guide (QRG) has basic information about
using the CT-TENT. For the latest information on the CT-TENT and other
TRUSST products, see the TRUSST website at www.trusst.com.
The information and specifications contained in this QRG are subject to
change without notice.
The following Safety Notes include important information about installation
and use.
Use only on clear span tent Keder beam.
•
• Carefully inspect the bracket and welding points before use.
Only trained personnel should attach the CT-TENT to tent beams.
•
For semi-permanent installation applications, check integrity of welds,
•
joints and clamp tightness weekly.
Install the CT-TENT properly; making sure the clamp is fully seated in
•
the slots of the Keder beam.
• DO NOT use the CT-TENT for loads that exceed the maximums
provided in this document.
DO NOT use the CT-TENT if it appears damaged in any way.
•
DO NOT use the CT-TENT if the arms, mounting plate or connecting
•
hardware are bent.
DO NOT sideload the eye bolt of the CT-TENT clamp.
•
DO NOT use a CT-TENT clamp that has been dropped.
•
CAUTION: The maximum load capacity for the CT-TENT is 1100 lb
(500 kg). DO NOT exceed this rating. Please check the specifications of
the tent before using this clamp. The Safe Working Load of the tent
may be lower than this clamp.
DO NOT over-tighten the bolt. Too much torque can damage the bolt,
damage the thread or fracture the welding joint.
Visit http://www.trusst.com/
contact your distributor to request support or return a product.
for contact information. Outside the U.S.,
2
EN