Belkin TuneBase Manual Del Usuario página 10

Using the TuneBase FM
Manually Selecting an FM Frequency
If you want to use a specific frequency, you can manually select it on your TuneBase FM.
1. Tune your stereo to a frequency with a weak signal. If possible, try to find a frequency that
is not broadcasting a radio station.
2. Press the + or — button on your TuneBase FM to select the same frequency. Pressing
and holding either button will provide faster tuning.
Storing a Preset Frequency
When you find a clear FM frequency, you can store it for later use. You can store two radio
frequencies using the 1 and 2 preset buttons.
1. If you are not currently on the frequency you want to store, use the + or – buttons to
select the frequency.
2. To select a preset frequency, press the 1 or 2 preset button. Your TuneBase FM will
change to the preset frequency.
Selecting a Preset Frequency
'Press and hold the 1 or 2 preset button for two seconds. You will hear a beep when the
new frequency is programmed'
Before using the Audio-Out function deactivate the FM Transmitter by pressing and holding
the Pro Button (see page 8) for 3 seconds. "Line" will appear in the LCD to confirm function
is in use
Using the Audio-Out Jack and a Cassette Adapter
Your TuneBase FM is equipped with a 3.5mm audio-out jack. If you cannot find a clear FM
frequency, you can connect the 3.5mm audio-out jack on your TuneBase FM directly to your
stereo (if line-in is available) or to a cassette adapter ensuring that your TuneBase FM is OFF
before inserting jack. TuneBase FM MUST be turned OFF when inserting jack
To reactivate FM Transmitter repeat above steps. "FM" will appear in LCD to confirm FM
Transmitter is in use
Using the TuneBase FM
| EN-8