Product Overview; Operation Notes - Go Power GP-PC Serie Manual De Usuario

DESCRIPTION
The charge controller protects the battery from being overcharged by the solar energy as well as from being overused
by the loads. The charging characteristics include several stages which include automatic adaptation to the ambient
temperatures.
SYSTEM VOLTAGE
This product is intended for use at 12 V and 24 V system voltage.
BATTERY TYPE
The GP-PC is suitable for use with lead acid batteries (flooded, GEL, or AGM type).
LOW VOLTAGE DISCONNECT FUNCTION
To prevent the battery against over-discharge this function automatically switches off the load output at a battery voltage
lower than 11.0 V (12 V systems) or 22.0 V (24 V systems). As soon as the battery reaches a voltage of 12.8 V (12 V
systems) or 25.6 V (24 V systems), the load output is switched on again.
REGULATORY INFORMATION

2. OPERATION NOTES

WARNING: Indicates high voltage. Use caution when performing task.
CAUTION: Indicates a critical procedure for safe operation.
NOTE: Indicates important information for safe and easy installation and operation. It is important the battery
receives a full charge at least weekly. If not, the battery will get permanently damaged. The battery cannot
receive a full charge if the loads are too large for the system.
Please read the instructions and warnings in this manual before beginning installation.
Please do not disassemble or attempt to repair Go Power! products. Go Power! charge controllers do not contain user
serviceable parts.
[page 4] | gpelectric.com

1. PRODUCT OVERVIEW