Operation - Procom Heating PCK80T El Manual Del Propietario

IMPORTANT: Review and un-
derstand the warnings in the
Safety section, pages 2 and 3.
They are needed to safely oper-
ate this heater. Follow all local
ordinances and codes when
using this heater.
TO START HEATER
1. Follow all ventilation and safety information.
2. Locate heater to provide maximum circu-
lation of the heated air. Follow all location
requirements noted in Safety, pages
2 and 3.
3. Fill fuel tank with fuel and attach fuel cap.
Use only kerosene, #1/#2 diesel/fuel oil,
JET A or JP-8 fuels to avoid risk of fire or
explosion. Never use gasoline, oil drained
from crank cases, naphtha, paint thinners,
alcohol or other flammable fuels.
4. Plug heater's power cord into approved,
grounded, three-wire extension cord.
Extension cord must be at least 6 feet
(1.8 m) long.
Extension Cord Size Requirement
Standards/normes/Normas:
• 6 to 10 feet (1.8 to 3 m) long, use 18
UL 733 - Fourth Edition
CSA-B140.0-03
AWG (0.75 mm
CSA B140.8-1967
C
CSA C22.2 No.3-M1988
• 11 to 100 feet (3.3 to 30.5 m) long, use
16 AWG (1.0 mm
5,567,144
D663,813
• 101 to 200 feet (30.8 to 61 m) long, use
14 AWG (1.5 mm
5. Plug extension cord into standard 120
volt/60 hertz, 3-prong grounded outlet.
6. Turn thermostat knob to the desired tem-
perature setting.
If thermostat set temperature is higher
than the surrounding air temperature,
heater should ignite immediately. If heater
thermostat set temperature is lower than
surrounding air temperature, heater will
not ignite. Exposure to direct sunlight
or extreme cold may affect temperature
reading and/or thermostat operation.
6

OPERATION

) rated cord
2
) rated cord
2
D663,812
D663,815
) rated cord
2
www.usaprocom.com
The LED will flash for 8 seconds before
ignition. The LED will remain on during
heater operation, even if the heater is
cycled off by the thermostat. The LED will
flash rapidly if the heater shuts down for
any reason (Example: If out of fuel).
WARNING: This heater is
equipped with a thermostat.
Heater may start at any time.
TO STOP HEATER
1. Turn thermostat knob counterclockwise
to STANDBY.
2. Unplug heater when not in use.
TO RESET HEATER
1. Wait two minutes before restarting.
2. Turn thermostat knob to STANDBY for 10
seconds, then restart heater.
LED Light
50
40
STANDBY
START/RUN
`
ENCIENDA/OPERACION
`
DEMARRE/MARCHE
160111-02
Figure 3 - Controls Display
Thermostat Knob
THERMOSTAT F
60
THERMOSTATO F
70
80
90
ASSEMBLED IN THE USA BY:
ASSEMBLE AUX ETATS-UNIS PAR:
ENSAMBLADA EN LOS EE.UU.POR:
PROCOM HEATING, INC.
2800 GRIFFIN DRIVE
BOWLING GREEN, KY 42101
O
O
160177-01C