Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Appliance does not
work.
Appliance cools too
much.
The food is too
warm.
Heavy build-up of
frost, possibly also
on the door seal.
Unusual noises.
The compressor
does not start
immediately after
changing the
temperature setting.
Water on the floor or
storage shelves.
Possible Cause
Appliance is not switched on.
Main plug is not plugged in or is
loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Door seal is not air-tight
(possibly after reversing the
door).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
This is normal, no error has
occurred.
Check that the Drip tray is
housed properly.
Drip tray is full of water
11
Solution
Switch on the appliance.
Insert main plug.
Check fuse, replace if
necessary.
Electrical malfunctions are
to be corrected by an
electrician.
Turn the temperature
regulator to a warmer
setting temporarily.
Please look in the "initial
Start Up" section.
Open the door only as long
as necessary.
Turn the temperature
regulation to a colder setting
temporarily.
Please look in the
"installation location"
section.
Carefully warm the leaking
sections of the door seal
with a hair dryer (on a cool
setting). At the same time
shape the warmed door seal
by hand such that it sits
correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts after
a period of time.
See the "cleaning and care"
section.
Publicidad
