Using The Universal Remote Control; Battery Installation; Basic Controls; Receiver Controls - RCA RV-9968 Guía De Usuario

using the universal remote control

battery installation

The remote control operates on four batteries,
included with your system. Install them before
attempting to operate the remote.
1. Slide the battery compartment cover off the back
of the remote.
2. Insert 4 AAA batteries, matching the + and - ends
of each battery with the symbols in the
compartment.
3. Replace the cover.

Basic Controls

Your remote control is capable of operating most RCA
audio and video equipment. To use the remote control
effectively, always aim it directly at your receiver.
POWER Turns the AM/FM receiver off with two
presses. If you have multiple components turned on
and not the AM/FM receiver, pressing POWER once
turns off the last component turned on. Pressing
POWER again quickly turns off all other components.
VOL UP and DOWN Increases or decreases the
volume.
MUTE Turns off the receiver's sound. Press again to
restore the sound.

Receiver Controls

AM•FM Activates the tuner and toggles between the
AM band and the FM band.
CTR MODE Changes the Center mode when using
Dolby Pro Logic Surround or Dolby 3 Stereo surround
modes. Press once and the current mode appears. Press
again to change the mode.
16
S
TAPE CD
AM•FM
PLAY
REV
FWD
REC STOP PAUSE
GUIDE•RDM SKIP
ENTER
GO BACK¥DISC
MUTE
1 2 3
4 5 6
7 8 9
INPUT•SEEK ANTENNA
0
INFO CLEARRESET•REP DELAY
CH CTRL
MENU TV MENU
MOVE
SELECT
+
–
PIP SWAP PIP
CTR MODE
PLAYLIST
•
BY-PASS LEVEL
SWAP
AUDIO