SOLAR STRING
CODE
391160
391177
IP44
12m
WARNING
BEFORE STARING THE INSTALLATION OF THIS PRODUCT
, PLEASE READ ATTENTIVELY THE INSTRUCTIONS AND
KEEP THEM IN A SAFE PLACE.
THE INSTALLATION SHOULD BE PERFORMED BY QUALI-
FIED PERSONNEL.
THE IMPROPER HANDLING OF THE COMPONENTS
OR THE PRODUCT COULD DAMMAGE THE CORRECT
FUNCTIONING OF THIS DEVICE THUS CANCELLING THE
WARRANTY OF THE PRODUCER
THE WARRANTY OF THE PRODUCER IS CANCELLED IF
THE INSTALLATION IS NOT PERFORMED FOLLOWING
THE INDICATED IN REBT 2002.
THE APPLICATION ITC BT09-4 OF THE REBT IS MANDA-
TORY (INSTALLATION OF OVERVOLTAGE PROTECTORS
OF IN LINES AND RECEIVERS) FOR INDUSTRY INSTALLA-
TIONS AND PUBLIC LIGHTING. THE WARRANTY DOES
NOT COVER DAMMAGES PRODUCED BY OVERVOLTA-
GE ON RECEIVERS WITHOUT OVERVOLTAGE PROTEC-
TORS.
THE APPLICATION OF ITC BT19 ( INTERIOR OR RECEI-
VING INSTALLATIONS.GENERAL PRESCRIPTIONS) IS
MANDATORY.
THE APPLICATION OF ITC BT34 (INSTALLATIONS FOR
SPECIAL PURPOSES. FAIRS AND STANDS) IS MANDA-
TORY.
MAINTENANCE OF THE PRODUCT
ALL PRILUX CHRISTMAS LIGHTING MOTIF, NEED A
MAINTENANCE BEFORE BEING USED, IT MEANS TO
CHECK ALL THE CONNECTIONS (INCLUDED THE END
CAP) IN ORDER TO BE SURE THAT THE MATERIAL HAS
THE PERFECT TIGHTNESS.
LED COLOR
CABLE COLOR
Warm white
Dark green
Cool white
Dark green
50cm
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
MEASURE
SOLAR PANEL
12m
0,24W/2V/120mA
12m
0,24W/2V/120mA
INTRODUCTION
SOLAR STRING consists of a solar cell, a rechargeable battery and LED lights.
All these are preassembled.
During the day time, light from the sun charges up the batteries. At night, the
energy stored in the batteries is used to power the light. No other power or
connections are required. The length of time the light stays on is dependent
on how much sunlight has been received during the day.
SITING INSTRUCTIONS
1. The lights are designed for use OUTDOORS in an open (unshaded) loca-
tion.
2. Do not position or place near barbecues, heaters or any other direct
sources of heat.
3. The unit should be located where sunlight can fall directly on the unit.
Shadows from buildings, trees, walls/hedges and similar objects should be
avoided if possible as these will reduce performance.
4. Try to avoid locations where light from other sources (e.g. streetlights,
floodlights etc) may effect the PIR sensor. The units are designed only to
illuminate in dark conditions, and may not come operate if light reflects on
the panel.
5. The units can be left outside in rain, but should not to be exposed to water
jets or immersed. For optimum life, the solar panel should be stored indoors
during extreme weather conditions (prolonged snow and frost).
6. Locate each light by insert the spike in the ground, choose a location
where there is soft ground to enable the spike to be pushed in easily.
USE INSTRUCTIONS
1. Remove all packaging before use and dispose of safely.
2. Ensure there are no pipes or mains cables immediately underneath, then
fix the solar panel assembly to the ground by the anchor spike.
3. Turn the ON/OFF switch at the bottom to "ON", change flash or steady
effect turn on "MODE"
4. Place the units at the desired locations. Ensure the cables are routed so
that they do not present a tripping hazard.
BATTERY REPLACEMENT
The battery is 1*AA NI-MH battery, be replaceable.
BULB CHANGING
This light set is constructed with non-replaceable bulbs. DO NOT attempt to
replace any of the bulbs in the light set.
WARNING
• The lights are designed for use OUTDOORS ONLY.
• Remove all packaging before use.
• This product is not a toy, keep out of reach of small children.
• This product has small parts, which may pose a choking hazard if deta-
ched.
• The end point of the ground stake is sharp. Please do not allow children to
play with the anchor.
BATTERY
1,2V/600mA
1,2V/600mA