Procedure For Reversing The Door - LG TDW15116G Manual Del Propietário

Secadora eléctrica a gas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INITIAL STEPS FOR INSTALLING YOUR DRYER
Part 3
Once in position, adjust the leveling legs of the dryer until it is level from left to right and from front to back.
The leveling leg must remain firmly on the floor and the dryer should not rock. The maximum slope of the dryer
from left to right or from front to back should not exceed 2.5 cm (1 inch). If the dryer is not level, and if the slope
exceeds 2.5 cm (1 inch), a load may not tumble properly and internal sensors may malfunction. Note: Other sec-
tions of this manual also provide important information concerning the placement of and clearances for your dryer.
Please review this entire manual before proceeding with any installation.
STEP 2
Procedure for Reversing
the Door
The door on your dryer can be installed to open either to the left or the right. Follow these procedures to reverse the
direction in which your door opens:
Note
Door and latch should be aligned at the center when closed. Otherwise, door is improperly closed and opened.
1
REMOVE FILLER PLUGS
Open the door and remove the filler plugs opposite the hinges.
2
REMOVE DOOR
With the door completely open, remove the BOTTOM
screw from each hinge on the dryer face.
Insert the screws about halfway into the TOP holes,
for each hinge, on the opposite side (where you
removed the filler plugs). Apply firm pressure to get
the screw started in new holes.
8
Loosen the TOP screw from each hinge on the dryer
face halfway. With one hand holding the top of the
door and the other hand holding the bottom, remove
the door from the dryer by lifting it UP and OUT.

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Tdw15117g

Tabla de contenido