Battery Backup; Setting The Clock - Naxa NRC-191 Manual De Operación

Connecting the Unit to
Power
Before plugging in the AC/DC power adapter to the
outlet, make sure that the voltage of your electric-
ity supply is same as that indicated on the rating
plate or power adapter.
The provided power adapter works
with AC 100-240V, 50/60 Hz power.

Battery Backup

Battery backup will preserve the current time, alarm
settings in the case of power failure or interrupt-
ed AC power.
Insert (2) two UM-4 batteries (AAA) into the battery
compartment. Be sure to observe the proper po-
larity (the "+" and "-" signs) as indicated inside the
battery compartment.
Page 6

Setting the Clock

Connect the AC power adapter to a wall
1.
outlet. The LED Display will illuminate
Press and Hold for 2-3 seconds the CLOCK/
2.
MEM button, the hour digit will ash.
3.
Press the Hour/SKIP- to adjust the Hour. Press
the MIN/SKIP- to adjust the Minutes.
4. Press and the CLOCK/ MEM button again to
con rm the time setting.
12-Hour / 24-Hour Mode
Press the SET/MEM button 3 times, "12H" or
"24H" will display. Press the
repeatedly to set the 12 or 24 hour format.
Take note of the PM LED indicator
when setting the time.
5.
Press the SET/MEM button repeatedly until
the actual time appears on the display to
exit.
or buttons
Naxa Electronics