Filter Installation And Maintenance - Shop-Vac Hippo B150 Serie Manual Del Usuario

SET UP AND OPERATION (CONT'D)
WARNING
FROM BEING BLOWN OR RICOCHETING INTO THE EYES OR FACE WHICH CAN RESULT IN SERIOUS
INJURY.
3. Wear safety goggles when operating vacuum. If more reach is desired, insert
flexible hose with desired tool. Optional blower nozzle will attach directly to rear
exhaust port, converting vacuum into a blower.

FILTER INSTALLATION AND MAINTENANCE

WARNING
TO SERVICE OR REMOVE ANY COMPONENTS.
The cleaning power and efficiency of the vacuum is completely dependent upon the filter system. This unit
is supplied with a disposable filter bag and a reusable secondary filter.
CHANGING DISPOSABLE FILTER BAG
1. Unplug electrical cord from outlet.
2. Remove tank by unlocking latch on each side of the tank.
3. Remove full bag by grasping cardboard collar and slowly sliding off plastic inlet.
4. To insert new bag, grasp cardboard collar as shown.
5. Place hole in cardboard collar over plastic inlet fitting and slide collar over inlet
fitting as far as it will go (be careful not to tear bag).
6. Expand filter bag by carefully pulling bag upwards so that entire filter bag is
positioned inside housing.
7. Reattach tank to power unit.
PAGE 6
–
ALWAYS WEAR EYE PROTECTION TO PREVENT ROCKS OR DEBRIS
–
BE SURE TO DISCONNECT POWER SUPPLY BEFORE ATEMPTING