Built-In Printer (Optional) - Circutor MD 5060e Manual De Uso

8. Built-in printer (optional)

In order to enable the printing function press key. Measured values
will be printed each 15 seconds, and the Dielectric Absorption Index and
Polarization Index will be printed after 1 minute and 10 minutes
respectively. Printing may be started or stopped at any time during the
test. However, it is convenient to turn the printer on before starting the
test in order to print it complete, including the heading.
ATTENTION: Don't pull the paper, always use the Paper feed key. Never
try to put the paper back into the printer. In any of these cases, the printer
can be easily damaged.
This printer uses 37 mm-wide thermal paper, which comes in a 33 mm-
diameter reel. The figure shown below indicates how to put the paper.
Press the Paper feed control (until the paper appears).
To remove the old paper reel, cut the paper next to it and press the Paper
feed control. The removal used-reel operation must be carried out in this
way due to the fact that the paper movement is in one-way only, that is,
the paper can be moved in one direction only.
65