Benavent CHBH300E Manual De Instrucciones página 43

Replace the lamp
The switch of LED lamp is gravity controlled, when the angle of door-opening is
bigger than 30. Degree, light will switch on and switch off when the angle is
smaller than 30 degree.
Notice:
When LED lamp does not work when door is open, please be released and check
as below steps:
1. Loosen screws on the lamp cover.
2. Loosen the screws fixed on the lamp electronic parts.
3. Check the cable terminals of electronic parts and terminals of contacting lines
for door lamp is loosening or not. Please fix them if the they are not fixed.
Then, check the light is on or not. If the lamp is switch on please install the
lamp cover; If not, please further check the electronic part is intact or not. If
necessary, please replace the electronic part to check the lamp is on or not.
If the lamp still does now work. Please contact with staff of after-sale lamp
installing.
The steps of LED lamp installing
x Fix the cable terminals of electronic parts and contacting lines in the door liner.
x Install LED electronic part in the door liner and fix on by screws.
x Install lamp cover on the holder and fix to finish all process.
1)
If the condenser is at back of appliance.
1)11
18